The solid control system also has some horizontal vacuum degasser equipped, its working principle is to use vacuum suction fluid, separated by the thin film after turbulent gas pumped by the vacuum pump. However, this horizontal vacuum degasser need to reprovision a pump spray unit, so that the degassed fluid pumped from the vacuum processing chamber.
Vacuum Degasser installation
(1) Drilling site requirements as long as no obvious tilt can be.
(2) inlet and outlet pipes, vacuum pumping line connections should be sealed and reliable.
(3) before the start of inlet and outlet pipes should end while immersed in the drilling fluid.
(4) Before the start of the first inlet hose on the vacuum pump and water pipe connected, stop for 3-5 minutes, and so filled with water after the pump is started again. At the same time, turn on the gas-water separator plugs, to the gas-water separator was filled with water until the water overflows from the overflow port stop and spin on the plugs. Start should check the motor rotation direction is correct.
(5) Vacuum control valve on the adjusting screw in place has been adjusted at the factory, do not casually adjusted.
Vacuum Degasser maintenance
(1) Vacuum degasser mud tank cover should be cleaned once a week, in order to avoid clogged gas channel.
(2) After use, the rotor should be washed and vacuum tank suction pipe, cut off the power, remove as the hole blocking plate to check parts for damage, and remove foreign objects inside the tank, rinse the tank wall and the rotor.
(3) After each using, the cleaning work should be carried out to ensure the re-use deaerator with good performance.
(4) Operating ambient temperature higher than 300C, the always see vacuum gauge, when the vacuum is less than 0.3 KPa, the water temperature should be maintained within the vacuum pump does not exceed 450C.
(5) For winter using, to promptly release the gas-water separator and pump the water to prevent cracking.
(6) Every month, available to the spindle bearing grease gun filled with sodium based grease filling volume 200ml.
Vacuum Degasser installation
(1) Drilling site requirements as long as no obvious tilt can be.
(2) inlet and outlet pipes, vacuum pumping line connections should be sealed and reliable.
(3) before the start of inlet and outlet pipes should end while immersed in the drilling fluid.
(4) Before the start of the first inlet hose on the vacuum pump and water pipe connected, stop for 3-5 minutes, and so filled with water after the pump is started again. At the same time, turn on the gas-water separator plugs, to the gas-water separator was filled with water until the water overflows from the overflow port stop and spin on the plugs. Start should check the motor rotation direction is correct.
(5) Vacuum control valve on the adjusting screw in place has been adjusted at the factory, do not casually adjusted.
Vacuum Degasser maintenance
(1) Vacuum degasser mud tank cover should be cleaned once a week, in order to avoid clogged gas channel.
(2) After use, the rotor should be washed and vacuum tank suction pipe, cut off the power, remove as the hole blocking plate to check parts for damage, and remove foreign objects inside the tank, rinse the tank wall and the rotor.
(3) After each using, the cleaning work should be carried out to ensure the re-use deaerator with good performance.
(4) Operating ambient temperature higher than 300C, the always see vacuum gauge, when the vacuum is less than 0.3 KPa, the water temperature should be maintained within the vacuum pump does not exceed 450C.
(5) For winter using, to promptly release the gas-water separator and pump the water to prevent cracking.
(6) Every month, available to the spindle bearing grease gun filled with sodium based grease filling volume 200ml.
No comments:
Post a Comment